![]() While a power drill/driver makes quick work of both drilling pilot holes and inserting screws, not everyone has one handy. Achieve a rough pilot hole without a power drill. Now you can go ahead and install your nail or screw. In a pinch, you can even use a bit of tape or a twist-tie to mark off the screw’s length on the drill bit. Once you hit the right depth, slowly back the drill bit out of the hole while continuing to keep the drill perpendicular to the wood. Many experienced do-it-yourselfers can eyeball the depth, but if you aren’t yet that experienced, you can use a drill stop to mark the appropriate depth. ![]() Photo: Know when to stop.ĭrill until your pilot hole is the same depth as the length of your screw or nail. Accelerate slightly if you feel confident you can control the drill otherwise, stay on a low speed. Start off with your drill set to low speed. Then, place the tip of your drill bit into the indentation you created earlier, holding the drill so the bit is perpendicular to the wood. Keep your drill bit perpendicular and slowly drill your pilot hole.īefore drilling into the wood, don protective eyewear so that you aren’t irritated by sawdust that flies out of the pilot hole. To prevent the top board from slipping or shifting ever so slightly as you drill, you may want to clamp them together, or even squeeze a bit of wood glue between the two boards (bonus: this strengthens the joint) and then clamp. This extra tool leaves both of your hands free to make sure that your drill is completely perpendicular to the wood. If you don’t have an exact match, go with the drill bit that’s slightly smaller than the screw’s body. The right drill bit covers the screw’s body, but not its threads. Hold the screw up in good light to make the task easier. While there are charts showing the appropriate size drill bit for various sizes of screws, you can do without by comparing drill bits to the screw until you find the one that matches.
0 Comments
Leave a Reply. |
Details
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |